Description
This sliding gate opener kit works for all gates up to 40ft long and weighing 1400lbs. This system features an auto-close option. You can set the gate to close in 12, 24, or 36 seconds after it opens. You can add up to 23 extra remotes to control this system. It uses an RF hopping code to prevent replay attacks, which makes it impossible for eavesdroppers to record the transmission to replay it later to open the gate. The gate must be on a level ground and cannot operate on a slope. In case of a outage or any emergency, you may also use a manual release key to open the gate.
Features:
Our sliding gate opener uses an AC motor. It has a supply of 200W. The high capacity and big torque allow up to 1400lbs bearing.
There are 4 buttons in the remote control. Press the button to open, close, and stop the gate. One gate opener can be controlled by up to 25 remotes.
This system features an auto-close option. You can set the gate to close in 12, 24, or 36 seconds after it opens. There is also a pedestrian mode that the gate will open about 1-5ft for people to pass through.
It uses an RF hopping code to prevent replay attacks, which makes it impossible for eavesdroppers to record the transmission to replay it later to open the gate.
There are 4 buttons in the remote control. Press the button to open, close, and stop the gate. One gate opener can be controlled by up to 25 remotes.
Specifications:
Maximum Gate Weight: 1400lbs
Maximum Gate Length: 40ft (includes 20ft of chain)
Supply: 110V AC, 60Hz
Gate Move Speed: 43ft/min (8.5"/second)
Motor Speed: 55RPM
Output : 200W
Remote Control Range: 100ft (Frequency: 433.92 MHz)
Output Shaft Height: 48mm
Max. Gate Weight: 1400lbs
Output Torque: 16Nm
Limit Switch: Magnetic Limit Switch
Noise: <56dB
Max # of Remotes 25
Duty Cycle: S2, 15 Minutes
Operating Temperature: -4°F~+122°F (-20°C~+50°C)
Package includes:
1*Sliding gate opener
2* Manual release keys
2* Remote controls
1*Box of accessories (2x 6M chains and a screw kit)
Can open gates up to 40ft long and weigh 1400lbs
Prevents your remote code from being accessible to others
4 buttons, corresponding to open/close/stop.